|
Post by darthflinstone on Nov 23, 2008 11:57:46 GMT -5
Which is the best of the old Horizon 1/6 Batman vinyl models is easiest to use to make an action figure? I have seen a few figures that look like they have used these kits but I am not sure if the actual model was cut up or were molds made? And of course which kits are best I have the revel one and one of the Horizon kits built but I am not sure if I have to cannibalize them or make molds any advice would be greatly appreciated.
|
|
kalel
Fine Citizen
Back finally but the moment has not been prepared for. :P
Posts: 240
|
Post by kalel on Nov 24, 2008 0:20:05 GMT -5
I haven't done it myself, however i do believe that some customisers mold the pieces for they assemble the model that way they can make the parts individually try: www.jimbobwan.comhe has a few tutorials on there and quite a few involved model kits to begin with, hope that helps.
|
|
|
Post by darthflinstone on Nov 24, 2008 18:08:47 GMT -5
Yes vary helpfull Thank you!
DF
|
|