|
Post by radioscooter on Sept 21, 2005 18:25:41 GMT -5
Hey guys, I am putting together a quick Mego Adam West to go with the Batcopter and I am using the Not Dolls head. (same head as on yours Marty) The question I have is - when you are using resin heads that have the mego style neck stump - what do you do to get it in the neck hole? Crack the chest? Heat up the resin? Sand it down to nothing? I'd like to keep the neck movable. Any thoughts?
-S
|
|
|
Post by BlackKnight on Sept 23, 2005 19:35:34 GMT -5
You figure it out yet Bro?
|
|
|
Post by martingb on Sept 26, 2005 6:49:45 GMT -5
I usually end up with a combination of sanding the neck plug and also shaving away a little of the hole on the neck of the body until the head just about 'pops' into place. This ensures it is firmly in place but also means it can move as an original Mego action figure head would have. Good luck mate.
|
|